Your ring, your data

COLMI R02_E700 · Talks straight to the ring over Bluetooth — no QRing, no account, no cloud. Everything stays in this browser on your phone.

Not connected Tap Connect and pick COLMI R02_E700 from the list. Unbind it from QRing first if it won't show up.

Ring

No data yet — connect the ring to see battery and firmware.

Measure now

Keep the ring snug and your hand still. Readings stream in live, about every 2 seconds.

—
No measurement running.
Pick one below to start.

Today

Downloads today's heart-rate history (every 5 minutes) and today's steps from the ring.

No data yet — nothing synced for today.
No step data yet — nothing synced for today.

Saved on this phone

Every reading and sync, newest first. Stored only in this browser — clearing Chrome's site data erases it.

No data yet — your readings will appear here.
Raw packet log for debugging ▾
(nothing yet — connect the ring)

Newest at the bottom · keeps the last 200 lines · reload the page to clear it.

Protocol tests running…

These run every time the page loads. They check the packet builder, checksum, battery / live-reading parsers, BCD time encoding, and the heart-rate & steps log parsers against known vectors from the open-source Python client (tahnok/colmi_r02_client), plus an empty-state check: with nothing synced, the page must say “No data yet” and never invent numbers.

Protocol: tahnok/colmi_r02_client (same as Gadgetbridge) · UART service 6E40FFF0 · Packets are 16 bytes, last byte is the checksum.
v2 (name-scan fix) — sleep, readiness scores and background sync come later.